Thickness-Dependent Gilbert Damping and Soft Magnetism in Metal/Co-Fe-B/Metal Sandwich Structure.

The achievement of the low Gilbert damping parameter in spin dynamic modulation is attractive for spintronic devices with low energy consumption and high speed. Metallic ferromagnetic alloy Co-Fe-B is a possible candidate due to its high compatibility with spintronic technologies. Here, we report thickness-dependent damping and soft magnetism in Co-Fe-B films sandwiched between two non-magnetic layers with Co-Fe-B films up to 50 nm thick. A non-monotonic variation of Co-Fe-B film damping with thickness is observed, which is in contrast to previously reported monotonic trends. The minimum damping and the corresponding Co-Fe-B thickness vary significantly among the different non-magnetic layer series, indicating that the structure selection significantly alters the relative contributions of various damping mechanisms. Thus, we developed a quantitative method to distinguish intrinsic from extrinsic damping via ferromagnetic resonance measurements of thickness-dependent damping rather than the traditional numerical calculation method. By separating extrinsic and intrinsic damping, each mechanism affecting the total damping of Co-Fe-B films in sandwich structures is analyzed in detail. Our findings have revealed that the thickness-dependent damping measurement is an effective tool for quantitatively investigating different damping mechanisms. This investigation provides an understanding of underlying mechanisms and opens up avenues for achieving low damping in Co-Fe-B alloy film, which is beneficial for the applications in spintronic devices design and optimization.

A Wide-Band Magnetoelectric Sensor Based on a Negative-Feedback Compensated Readout Circuit.

Magnetoelectric (ME) sensors cannot effectively detect broadband magnetic field signals due to their narrow bandwidth, and existing readout circuits are unable to vary the bandwidth of the sensors. To expand the bandwidth, this paper introduces a negative-feedback readout circuit, fabricated by introducing a negative-feedback compensation circuit based on the direct readout circuit of the ME sensor. The negative-feedback compensation circuit contains a current amplifier, a feedback resistor, and a feedback coil. For this purpose, a Metglas/PVDF/Metglas ME sensor was prepared. Experimental measurements show that there is a six-fold difference between the maximum and minimum values of the ME voltage coefficients in the 6-39 kHz frequency band for the ME sensor without the negative-feedback compensation circuit when the sensor operates at the optimal bias magnetic field. However, the ME voltage coefficient in this band remains stable, at 900 V/T, after the charge amplification of the direct-reading circuit and the negative-feedback circuit. In addition, experimental results show that this negative-feedback readout circuit does not increase the equivalent magnetic noise of the sensor, with a noise level of 240 pT/√Hz in the frequency band lower than 25 kHz, 63 pT/√Hz around the resonance frequency of 30 kHz, and 620 pT/√Hz at 39 kHz. This paper proposes a negative-feedback readout circuit based on the direct readout circuit, which greatly increases the bandwidth of ME sensors and promotes the widespread application of ME sensors in the fields of broadband weak magnetic signal detection and DBS electrode positioning.

Design of a Radial Vortex-Based Spin-Torque Nano-Oscillator in a Strain-Mediated Multiferroic Nanostructure for BFSK/BASK Applications.

Radial vortex-based spin torque nano-oscillators (RV-STNOs) have attracted extensive attention as potential nano microwave signal generators due to their advantages over other topological states, such as their higher oscillation, higher microwave power, and lower power consumption. However, the current driving the oscillation frequency of the STNOs must be limited in a small range of adjustment, which means less data transmission channels. In this paper, a new RV-STNO system is proposed with a multiferroic nanostructure, which consists of an ultrathin magnetic multilayer and a piezoelectric layer. Phase diagrams of oscillation frequency and amplitude with respect to piezostrain and current are obtained through micromagnetic simulation. The results show that the threshold current density of -4000-ppm compressive strain-assisted RV-STNOs is reduced from 2 × 109 A/m2 to 2 × 108 A/m2, showing one order of magnitude lower than that of conventional current-driven nano-oscillators. Meanwhile, the range of oscillation frequency adjustment is significantly enhanced, and there is an increased amplitude at the low oscillation point. Moreover, a promising digital binary frequency-shift key (BFSK) and binary amplitude-shift key (BASK) modulation technique is proposed under the combined action of current pulse and piezostrain pulse. They can transmit bit signals and show good modulation characteristics with a minimal transient state. These results provide a reference for developing the next generation of spintronic nano-oscillators with a wide frequency range and low power consumption, showing potential for future wireless communication applications.

Prognostic model of lung adenocarcinoma constructed by the CENPA complex genes is closely related to immune infiltration.

BACKGROUND: Lung adenocarcinoma (LUAD) is still one of the primary malignant diseases leading to higher mortality worldwide. It has been previously reported that multiple genes in the CENPA-nucleosome associated complex (NAC) complex in lung cancer can be used as prognostic markers; however, there is lack of comprehensive research on the CENPA-NAC complex. METHODS: The hub genes of lung cancer were obtained by analyzing multiple gene expression omnibus (GEO) lung cancer datasets. The key genes of the CENPA-NAC complex in the evolution of LUAD were identified according to lung cancer data obtained from The Cancer Genome Atlas (TCGA) database, and the key genes were constructed as a survival prognostic model. The relationship between the model and immune cell infiltration was studied by the Tumor Immune Estimation Resource (TIMER) and single-sample gene set enrichment analysis (ssGSEA) studies.Droplet Digital polymerase chain reaction (ddPCR) was used to verify the effectiveness of the prognostic model to predict survival using clinical samples. RESULTS: A comprehensive study showed that CENPA, CENPH, CENPM, CENPN and CENPU were key genes in the development and evolution of LUAD. The constructed survival prognosis model was an independent risk factor for LUAD and can be used to assess the survival of LUAD patients. The risk score was closely related to the infiltration of multiple immune cells. The independent cohorts GSE31210 and GSE50081 further confirmed the validity of the prognostic model, and finally, the model was validated with clinical samples. CONCLUSIONS: In conclusion, the results of the present study showed that CENPA, CENPH, CENPM, CENPN, and CENPU are a group of potential prognostic markers in LUAD. The constructed model has been confirmed to be applicable in the clinical setting in evaluating the survival of patients with LUAD, and providing more evidence on immunotherapy for LUAD.

Molecular subtypes based on ferroptosis-related genes and tumor microenvironment infiltration characterization in lung adenocarcinoma.

Recently, several molecular subtypes with different prognosis have been found in lung adenocarcinoma (LUAD). However, the characteristics of the ferroptosis molecular subtypes and the associated tumor microenvironment (TME) cell infiltration have not been fully studied in LUAD. Using 1160 lung adenocarcinoma samples, we explored the molecular subtypes mediated by ferroptosis-related genes, along with the associated TME cell infiltration. The ferroptosis score was constructed using the least absolute shrinkage and selection operator regression (LASSO) method to quantify the ferroptosis characteristics of a single tumor. Three different molecular subtypes related to ferroptosis, with different prognoses, were identified in LUAD. Analysis of TME cell infiltration revealed immune heterogeneity among the three subtypes. Cluster A was characterized by immunosuppression and was associated with stromal activation. Cluster C was characterized by a large number of immune cells infiltrating the TME, promoting tumor immune response, and it was significantly enriched in immune activation-related signaling pathways. Relatively less infiltration of immune cells was a feature of cluster B. The ferroptosis score can predict tumor subtype, immunity and prognosis. A low ferroptosis score was characterized by immune activation and good prognosis, as seen in the cluster C subtype. Relative immunosuppression and poor prognosis were the characteristics of a high ferroptosis score, as seen in cluster A and B subtypes. At the same time, the anti-PD-1/L1 immunotherapy cohort demonstrated that a low ferroptosis score was associated with higher efficacy of immunotherapy. The ferroptosis score is a promising biomarker that could be of great significance to determine the prognosis, molecular subtypes, TME cell infiltration characteristics and immunotherapy effects in patients with LUAD.

NEIL3 may act as a potential prognostic biomarker for lung adenocarcinoma.

BACKGROUND: Lung adenocarcinoma (LUAD) is the leading cause of cancer-related death. This study aimed to develop and validate reliable prognostic biomarkers and signature. METHODS: Differentially expressed genes were identified based on three Gene Expression Omnibus (GEO) datasets. Based on 1052 samples' data from our cohort, GEO and The Cancer Genome Atlas, we explored the relationship of clinicopathological features and NEIL3 expression to determine clinical effect of NEIL3 in LUAD. Western blotting (22 pairs of tumor and normal tissues), Real-time quantitative PCR (19 pairs of tumor and normal tissues), and immunohistochemical analyses (406-tumor tissues subjected to microarray) were conducted. TIMER and ImmuCellAI analyzed relationship between NEIL3 expression and the abundance of tumor-infiltrating immune cells in LUAD. The co-expressed-gene prognostic signature was established based on the Cox regression analysis. RESULTS: This study identified 502 common differentially expressed genes and confirmed that NEIL3 was significantly overexpressed in LUAD samples (P < 0.001). Increased NEIL3 expression was related to advanced stage, larger tumor size and poor overall survival (p < 0.001) in three LUAD cohorts. The proportions of natural T regulatory cells and induced T regulatory cells increased in the high NEIL3 group, whereas those of B cells, Th17 cells and dendritic cells decreased. Gene set enrichment analysis indicated that NEIL3 may activate cell cycle progression and P53 signaling pathway, leading to poor outcomes. We identified nine prognosis-associated hub genes among 370 genes co-expressed with NEIL3. A 10-gene prognostic signature including NEIL3 and nine key co-expressed genes was constructed. Higher risk-score was correlated with more advanced stage, larger tumor size and worse outcome (p < 0.05). Finally, the signature was verified in test cohort (GSE50081) with superior diagnostic accuracy. CONCLUSIONS: This study suggested that NEIL3 has the potential to be an immune-related therapeutic target and an independent predictor of LUAD prognosis. We also developed a prognostic signature for LUAD with a precise diagnostic accuracy.

Correlation between prognostic indicator AHNAK2 and immune infiltrates in lung adenocarcinoma.

BACKGROUND: Lung adenocarcinoma (LUAD) is among the most aggressive malignant tumors in humans. Although AHNAK nucleoprotein 2 (AHNAK2) is considered a new oncogene, the function of the AHNAK2 in LUAD remains unknown. METHODS: Oncomine, Tumor Immune Estimation Resource (TIMER), and Human Protein Atlas databases were used to investigate AHNAK2 expression in LUAD. Gene Expression Profiling Interactive Analysis and Kaplan-Meier plotter databases were employed to elucidate the relationship between AHNAK2 and survival time. Data of The Cancer Genome Atlas were downloaded to analyze the correlation between AHNAK2 and clinicopathological parameters. We then immunohistochemically stained tissue chips to further confirm the correlation and conducted Gene Ontology, Kyoto Encyclopedia of Genes and Genomes, and protein-protein interaction network analyses to explore the possible functional mechanism of AHNAK2. Finally, we investigated the relationship between AHNAK2 and tumor infiltrating immune cells (TIICs). RESULTS: AHNAK2 gene was significantly overexpressed in LUAD tumor tissues and an independent prognostic indicator of LUAD patients. The expression of AHNAK2 was related to disease stage, differentiation, tumor size and lymph node metastasis. We found AHNAK2 expression was mainly positively correlated with cell adhesion-related pathways and negatively correlated with oxidative phosphorylation and amino acid metabolism. AHNAK2 expression was also negatively correlated with activated B cell, activated CD8 + T cell, and immature B cell infiltrates and positively correlated with central memory CD4 + T cell, tumor-associated macrophage, M1 macrophage, and M2 macrophage infiltrates. CONCLUSION: Our findings provide strong evidence of AHNAK2 expression as a prognostic indicator related to TIICs in LUAD.

Voltage control of magnetic domain wall injection into strain-mediated multiferroic heterostructures.

Effective control of domain wall (DW) injection into magnetic nanowires is of great importance for future novel device applications in spintronics, and currently relies on magnetization switching by the local external magnetic field obtained from metal contact lines or a spin-transfer torque (STT) effect from spin-polarized current. However, the external field is an obstacle for realizing practical spintronic devices with all-electric operation, and high current density can occasionally damage the devices. In this work, voltage controlled in-plane magnetic DW injection into a magnetic nanowire in the strain-mediated multiferroic heterostructures is studied by means of fully coupled micromagnetic-mechanical Finite Element Method (FEM) simulations. We propose an engineered shaped nano-magnet on a piezoelectric thin film in which a 180° magnetization rotation in the DW injection region is accomplished with in-plane piezostrain and magnetic shape anisotropy, thereby, leading to a DW injection into the nanowire. In this architecture, we computationally demonstrate repeated creation of DWs by voltage-induced strains without using any magnetic fields. Our FEM simulation results demonstrated an ultralow area energy consumption per injection (∼52.48 mJ m-2), which is drastically lower than the traditional magnetic field and STT driven magnetization switching. A fast-overall injection time within ∼3.4 ns under continuous injection is also demonstrated. Further reduction of energy consumption and injection time can be achieved by optimization of the structure and material selections. The present design and computational analyses can provide an additional efficient method to realize low-power and high-speed spintronic and magnonic devices.

Wind-blown Sand Electrification Inspired Triboelectric Energy Harvesting Based on Homogeneous Inorganic Materials Contact: A Theoretical Study and Prediction.

Triboelectric nanogenerator (TENG) based on contact electrification between heterogeneous materials has been widely studied. Inspired from wind-blown sand electrification, we design a novel kind of TENG based on size dependent electrification using homogeneous inorganic materials. Based on the asymmetric contact theory between homogeneous material surfaces, a calculation of surface charge density has been carried out. Furthermore, the theoretical output of homogeneous material based TENG has been simulated. Therefore, this work may pave the way of fabricating TENG without the limitation of static sequence.